THANKS FOR READING IT ALL đ€
Rake shims for WING FOIL â Made with 3D printing
Please choose your mast type, Regular or Performance. Since the plate outline differs, it’s essential to select the model that matches yours.
– Pack of 3 shims : 0.5°/1.0°/1.5°
– Pack of 2 shims : 0.8°/1.5°
– 1 shim of your choice: 1.0°/1.5°
– 1 custom-angled shim (max 2.0°) / Specify by email when ordering
IMPORTANT :
– « + » shims increase your rake: you’ll ride more « nose up, » with the front of the board higher on the water.
« â » shims reduce your rake: you’ll ride more « nose down, » with the front of the board lower on the water.
The rake shim has a certain thickness (7mm for 1.5° shims), so make sure your original screws are long enoughâitems like « 4 M8X40 screws » or « 4 M6x40 screws » from the store may be helpful.
Place the smooth side of the shim against the board hull â the print marks on the other side could leave traces.
– TempĂ©rature limite d’utilisation : 60°C / Attention au stockage dans les vĂ©hicules en plein soleil.