NOLIMITZ – WINGFOIL rake shims

THANK YOU FOR READING IT ALL 🤙

Rake shims for WING FOIL – 3D printed
– Pack of 3 shims : 0.5°/1.0°/1.5°
– Pack of 2 shims: 0.8°/1.5°
– 1 shim of your choice: 1.0°/1.5°
– 1 custom-angle shim (max 2.0°) / Specify by email when ordering
IMPORTANT:
– The “+” shims increase your rake: you’ll ride more “nose up,” with the front of the board higher on the water.
The “–” shims reduce your rake: you’ll ride more “nose down,” with the front of the board lower on the water.
The rake shim has a certain thickness (7mm for 1.5° shims), so make sure your original screws are long enough — the “4 M8X40 screws” or “4 M6x40 screws” from the shop may be useful.
Position the smooth side of the shim against the hull — the print marks on the other side could leave marks.

Maximum operating temperature: 60°C / Be careful when storing in vehicles under direct sunlight.