AFS Plate V2 – WINGFOIL Rake Shims

THANK YOU FOR READING EVERYTHING 🤙

Rake shims for WING FOIL – 3D printed.
– Pack 3 shims : 0.5°/1.0°/1.5°
– Pack of 2 shims: 0.8°/1.5°
– 1 shim of your choice: 1.0°/1.5°
– 1 custom angle shim (max 2.0°) / To be specified by email when ordering
IMPORTANT:
– The “+” shims increase your rake: you’ll ride more “nose up”, with the nose higher above the water.
The “–” shims reduce your rake: you’ll ride more “nose down”, with the nose lower on the water.
For symmetrical baseplates, the shims are reversible, so there’s no difference between “–” and “+” shims.

The rake shim has a certain thickness (7mm for 1.5° shims), so make sure your original screws are long enough; the “4 M8X40 screws” or “4 M6x40 screws” available in the shop might be useful.
Place the smooth side of the shim against the board – the print marks on the other side could leave marks.

Maximum operating temperature: 60°C / Be careful when storing in vehicles under direct sunlight.