GONG CARBON V2 Plate – Rake shims for WINGFOIL

THANK YOU FOR READING EVERYTHING 🤙

Rake shims for WING FOIL – 3D printed.
3-shim pack: 0.5°/1.0°/1.5°
– Pack of 2 shims: 0.8°/1.5°
– 1 shim of your choice: 1.0°/1.5°
1- custom angle shim (max 2.0°) / Specify by email when ordering
IMPORTANT:
– “+” shims increase your rake: you’ll ride with a higher nose (“nose up”) on the water.
“-” shims reduce your rake: you’ll ride with a lower nose (“nose down”) on the water.
The rake shim has a certain thickness (7mm for 1.5° shims), so check if your original screws are long enough; the item “4 screws M8X40” or “4 screws M6x40” from the store may be useful.
Place the smooth side of the shim facing the hull—the print marks on the other side could leave traces.
Maximum operating temperature: 60°C / Avoid storing in vehicles under direct sunlight.