THANKS FOR READING IT ALL 🤙
Rake shims for WING FOIL – Made with 3D printing
IMPORTANT :
The “+” shims increase your rake: you’ll ride more “nose up,” with the nose higher on the water.
The “–” shims decrease your rake: you’ll ride more “nose down,” with the nose lower on the water.
Rake shims have a certain thickness (7 mm for 1.5° shims), so make sure your original screws are long enough — the “4 M8x40 screws” or “4 M6x40 screws” available in the shop may be useful.
Place the smooth side of the shim against the board hull — the print lines on the other side could leave marks.
Loic C. –
Livraison hyper rapide en Guadeloupe !
Merci beaucoup…vivement que le vent revienne pour essayer 😉
Marc L. –
Très bonne expérience
Antonin est d’excellent conseil, ne pas hésiter à rentrer en contact avec lui avant d’acheter !
Jerome D. –
Produit adapté et conforme à mes attentes
Marc E. –
AP3D toujours au top, merci pour les conseils et la réactivité !
Antoine P. –
Bien reçu en temps et en heure super qualité 🤙
Jerome D. –
Nickel conforme et costaud
Stephane T. –
Good finish. Fast delivery