THANKS FOR READING IT ALL 🤙
Rake shims for WING FOIL – Made with 3D printing.
– Pack of 3 shims : 0.5°/1.0°/1.5°
– Pack of 2 shims : 0.8°/1.5°
– 1 shim of your choice: 1.0°/1.5°
1 custom angle shim (max 2.0°) / Please specify by email when ordering
IMPORTANT :
– The “+” shims increase your rake: you’ll ride more “nose up”, with the front of the board higher on the water.
– The “–” shims decrease your rake: you’ll ride more “nose down”, with the front of the board lower on the water.
– The rake shim has a certain thickness (7mm for 1.5° shims), so make sure your original screws are long enough. The “4 M8X40 screws” or “4 M6x40 screws” available in the shop may be useful.
– Place the smooth side of the shim against the board hull – the print marks on the other side could leave marks.
– Maximum operating temperature: 60°C / Be careful when storing in vehicles under direct sunlight.
