THANK YOU FOR READING EVERYTHING 🤙
Rake shims for WING FOIL – 3D printed
Since there are different versions of ALU plates from FONE, please check—using the picture—that the shim has the same outline as your plate. If you’re unsure, just contact me.
– Pack of 3 shims: 0.5°/1.0°/1.5°
– Pack of 2 shims : 0.8°/1.5°
Single shim: Choose between 1.0° and 1.5°
1 custom angle shim (up to 2.0°) / Please specify by email when ordering
IMPORTANT :
The “+” shims increase your rake: you’ll ride with a higher nose (more “nose up”) while foiling.
The “–” shims decrease your rake: you’ll ride with a lower nose (“nose down”) on the water.
The “–” shims decrease your rake: you’ll ride with a lower nose (“nose down”) on the water.
The rake shim has a certain thickness (7 mm for the 1.5° shims). Make sure your original screws are long enough. The “4 x M8x40 screws” or “4 x M6x40 screws” available in the shop might be useful.
Place the smooth side of the shim against the board – the 3D print marks on the other side could leave marks.
Maximum operating temperature: 60°C / Be careful when storing in vehicles exposed to direct sunlight.
Mainka J. –
Livraison très rapide et parfaitement adapté à mon foil fone
Jean-philippe D. –
Top idée et beau travail, merci!
Leman G. –
Ça change la vie pour corriger le scoop de mon sup. Je pars désormais sur rien !! C’est indispensable. Pas donné pour un bout de plastique mais bien réalisé, sur mesure, et vraiment très efficace.
Luc J. –
Good product – clear communication – correct shipment
Thierry C. –
Produit de qualité ,qui a grandement amélioré mon glide et mon pumping, le décollage et le freefly s’en sont retrouvés facilités